|
| | Dominator Inducer
New Product
TheINDUCER
Part No. IMI 000
The Inducer impeller is a revolutionary new concept that feeds water to the jet.
Because theInducer is not shrouded it can flow 20% more water to the impeller than the
impeller can use. This helps keep the impeller loaded and absorbing all the power the engine can
produce.
Problem: Pulling skiers with small impellers (B or C) and high performance
engines. The small impeller does not work well for the hole shot but is designed to let the
motor turn more RPM at top end to reach desired speeds. This makes pulling skiers near
impossible. Solution: The inducer impeller is designed to feed enough water to the impeller
to keep it hooked up. Resulting in tremendous hole shot and the ability to pull skiers.
This does not affect the top end speed. Problem: Heavy white water. In turbulent white water the jet takes a gulp of air
causing the impeller to spinout while negotiating a large rapid. In some cases the jet can
take too long too recover resulting in a potentially dangerous situation. Solution: The inducer feeds water to the impeller almost instantaneously.
Resulting in no loss of forward progress. Problem: Large heavy boats with a radical engine. The large boat dictates that
the impeller should also be large. By using a large impeller hole shot is increased but the
motor cannot turn the appropriate RPM to reach desired top speed. Solution: By using a smaller impeller along with the inducer a person can have
the best of both worlds and not sacrifice hole shot or top end.
|
